High Quality Dental Unit - AM100 Alginate Mixer – JPS DENTAL

Voltage: 220V-240V/50HZ-60HZ        

Power:400W         

Revolution:3000r.p.m/50HZ; 3000r.p.m/60HZ

Scope of timing：4-16s

Mode of Memory：5 kinds

Automatic computer control & Numeral display

5 pre-set programs

Fit for different moulage material and different mixed dosage

1. Imported motor, low noise and long service life

2. Microcomputer control, safe and reliable operation;

3. After mixing, the impression material has no bubbles, good elasticity, not easy to deform, and mold taking is clearer;

4. The setting time range is long, within 1-24 seconds, the user can choose according to the characteristics of different impression materials;

5. Three kinds of computer memories can be set according to user needs (the factory setting is 8 seconds “one spoon of powder”, 10 seconds two spoons of powder”, 12 seconds “three spoons of powder”>;

6. The internal temperature control of the product is reliable, and it can work continuously for a long time without affecting the production of impression materials; it runs with low noise and is easy to operate.

(1) There is a vent hole on the top of the mixing bowl cover. Please clean it to ensure that it is not blocked by impression powder and other sundries.

(2) The weight of each mixing (total weight of water and impression powder) should be 25g-75g. If the weight of the mixture is out of this range, the noise of the machine will increase, and there will even be abnormal noises such as impacts, which may damage the machine in severe cases.

(3) The optimal mixing weight designed for this machine is 58g , which is the best state of the machine at this time.

(4) For the ratio of impression powder and water during mixing, please refer to the standard of the impression powder manufacturer. The supplied water bottle can help measure the amount of water required. Unscrew the bottle body and fill it with mixing water. After tightening, squeeze the bottle body by hand to measure the amount of water (you can also use the special instrument provided by the impression powder manufacturer to measure. According to our experience, a slight increase in the proportion of water will make The mixed impression powder is more delicate, but this will slightly increase the curing time).

(5) The temperature of the stirring water should be 10-20°C, otherwise the curing time will be shortened, which is not conducive to operation (especially in summer).